STS, Silver Thiosulfate. Kits to make Feminized Seeds + GA3

Fresh ingredients!

I've personally used this non stop for years now. I mix a new batch for myself once a month, and it works flawlessly. 100%

I spray basically when I can, at least once a week, but not more than once every 3 days.

This is a 2 part mix to make 8 ounces (236ml) of 3.4mM strength STS (Silver Thiosulfate). That's .4mM stronger than recommended by the American Society for Horticultural Sciences- search: "Foliar Sprays of Silver Thiosulfate Produce Male Flowers on Female Hemp Plants"

This is made from very high quality, Reagent Grade, Sodium Thiosulfate Anhydrous, Silver Nitrate, and only distilled water.
It can be stored in the separate containers, until you are ready to use.
Once they are mixed, the solution should be used within 30 days.
It takes approximately 21 days to start getting pollen.
I like to spray every 3 to 5 days, but once a week has never failed me either.

Caution: Be sure to isolate your plant when spraying. This will cause plants to hermy if accidentally sprayed even once!

What you will need:

200ml of distilled, or pure RO water (No tap, or well water).

A spray bottle if buying the refill kit.

What is included:
1- 8OZ (250ml) Amber, Fine Mist Spray Bottle. (Full Kit only)
Part A (Silver Nitrate)- This blocks the production of ethylene necessary to make female flowers.
Part B (Sodium Thiosulfate)- This is the carrier that enables the silver to penetrate well into the plant.

Now includes 1 dose of OPTIONAL Gibberellic Acid (GA3) to stretch the male flowers out away from each other, keeping the pollen dryer, and making it easier for the flowers to open up.

Also included is a booklet of instructions for timing, and the spray schedule for both Photoperiods, and Autoflowers.
Also tips for stubborn plants, and pollen collection and storage.

The STS solutions contain:

8ml of 10mM Silver Nitrate solution, and

32ml of 10mM Sodium Thiosulfate Anhydrous solution.

When combined this makes 40ml of concentrated Silver Thiosulfate solution of 20mM strength.

This needs to be diluted down to around 3mM.

I’ve tested 1, 3, 5, 10, and 20mM solutions, and this is my favorite, which gets 100% success without burning the developing male flower pods.

Instructions to make smaller 1 ounce and 4 ounce batches are included.

Thank you for your support!!!